Installation and Removal

Installation:

Start with the barrel and guide rod installed in the slide

Insert spring and then insert spring cap.

Depress the spring cap with thumb. With spring cap depressed, insert compensator and twist into place.

 

Removal:

Insert the back side of a 3/8” drill bit or dowel pin with a diameter of .399" to depress spring cap.

Twist compensator counterclockwise to the 4 0’clock position

Remove compensator.

If you are still having trouble removing the compensator make sure you are depressing the spring plug all the way down to clear the locking lug then rotate to the 4 0' clock position. You can use a slim tool like a thin file.  Sometimes if you are not depressing the spring plug far enough you can get hung up on the locking lug making removal difficult . 

 

DO NOT force the compensator onto your barrel.  These may require minor fitting depending on your barrel and slide combination, but should fit right onto a stock configured gun.  I highly encourage you to contact me or visit a gunsmith if you have any issues regarding the fit of the compensator.
Only use Standard Ammunition with these compensators.
DO NOT use over pressure rounds ie P+ or P++


 

 CONTACT US AT: askteamvalkyrie@gmail.com